Electrician for CoC Inspections

Got your trade test and a steady hand on a DB board? This facilities management company in Mthatha needs you on the tools. You don't need to be the loudest person in the room, just the one others can count on.

You'll report in Mthatha. Relocation is not covered for this one. You'll start with a short induction before working on your own.

• Test installations and issue Certificates of Compliance where your registration allows
• Replace faulty light fittings, plugs, geyser elements and thermostats
• Complete job cards, material lists and test reports at the end of each job
• Run conduit, trunking and cable tray on new builds and renovations
• Install and wire distribution boards, isolators and earth leakage units to SANS 10142-1
• Lock out and tag out circuits before any work on live equipment

• Solid working knowledge of SANS 10142-1 and the Electrical Installation Regulations
• Electrical trade test certificate (Section 13 or 26D) through a QCTO-accredited centre
• Your own basic hand tools and a calibrated multimeter
• Clean criminal record, since you will work inside client homes

• N3 electrical trade theory on top of your trade test
• PLC and motor control experience from a factory setting
• Master Installation Electrician registration for three-phase CoCs

• Company bakkie for call-outs and travel between sites
• Overtime paid at time-and-a-half on weekends
• Provident fund and group risk cover after probation

• If you have issued CoCs before, say how many and for what type of property.
• Put your registration category (IE, MIE or single-phase tester) and registration number right under your name on the CV.